← Research questions and evidence

Interactive ecology

When environmental pressures combine

Run a fictional heatwave and fungicide experiment, explore synergy and antagonism, and follow what happens after exposure ends.

Sources and further reading

01 · Expected and observed effects

A heatwave and
fungicide exposure.

In freshwater, a heatwave is a period of unusually warm water. A fungicide is a chemical used to control fungi. Explore what could happen when these pressures occur together or in different orders.

Build an experiment

Fictional experiment
Single-exposure cluessurvivors / 100
Neither100
Heatwave80
Fungicide70

Drag the fungicide, heatwave or both into the tank. You can also select an icon and then + to add it. Press Escape to cancel a selection.

Start · Neither stressor
Neither stressor

100 animals, ready to start

Make your call

How many survive?

Use the slider to predict how many of the 100 animals survive.

All numbers are invented for learning, not findings or predictions for a real species.

How to read this experiment

What is being compared?

Each group starts with 100 animals. Survival is measured after seven days. An empty setup runs the unexposed control. Adding both icons exposes the group to both pressures for the same seven days. Heatwave conditions and fungicide concentration are held the same in the single and combined treatments. The icons do not adjust dose or temperature.

The single-exposure results alone cannot determine the combined result. Matching the count is a good guess for this example, not evidence that someone could predict a real experiment.

02 · Making sense of the result

More harm, less harm,
or what we expected?

In the seven-day example, the heatwave alone kills 20 of 100 animals. The fungicide alone kills 30. Should exposing animals to both kill 50? That is one expectation, but it is not the only one.

Additivity

The losses add up. Here, 20 + 30 deaths would leave 50 survivors. This is the simple-addition reference.

Synergy

The combined harm is greater than the chosen reference predicts. For survival, that means fewer animals remain alive.

Antagonism

The combined harm is smaller than the chosen reference predicts. There can still be substantial harm.

What should “expected” mean?

Choose a reference expectation

100 × 0.80 × 0.70 = 56

Multiply the two survival proportions. This assumes independent effects on survival and allows for overlapping losses. It uses the example’s 100% survival in the control.

Different processes can produce the same count. In a real study, choose a reference that fits the biological question and explain why. Why the reference matters ↗

Worked example, seven-day exposure

Synergy, more harm than expected

16 fewer animals survive than expected, so there are 16 more deaths.

60 animals died. The comparison uses survival at the same time point.

Run both stressors together above to connect this panel to your result. Until then, these are worked examples.

Other possible results, with the same single exposures

Each choice is a different invented outcome, not animals dying or returning to life in the same experiment. These choices change only this worked example.

Before you move on

Suppose 53 survive. What would you call it?

The two single-exposure results have not changed.

Why might the combination do something different?

One possible route to greater harm
More demand, less capacity

Warmer water can change how quickly a chemical enters and leaves an animal. Coping with heat and dealing with chemical damage can also draw on limited energy. If one exposure leaves less capacity to cope with the other, the combined effect could be stronger. These are possibilities to test, not explanations established by our fictional counts.

Temperature and chemical uptake ↗A published model of combined stress ↗
One possible route to less harm
Some of the losses overlap

The animals most vulnerable to one stressor may also be vulnerable to the other. If these vulnerabilities overlap more than the reference assumes, the combined harm can be smaller than expected. Other combinations may alter exposure or trigger protective responses. Antagonism therefore does not necessarily mean the stressors cancel each other out.

Susceptibility and reference models ↗A mayfly experiment with changing interactions ↗

A label describes a comparison, not a cause. A real study needs independent replicate tanks and uncertainty estimates. To find out why a result occurred, we would also need measurements such as chemical concentrations inside animals, feeding or energy reserves. An interaction in survival need not be the same for growth, or remain the same after recovery.

What happens after exposure ends?Explore recovery and feedbacks

03 · Lasting effects and feedbacks

The heatwave is over.
What happens next?

The water can return to its usual temperature before an animal recovers. But a lingering effect and a feedback are different things. What would we need to measure to tell them apart?

04 · Further reading

The science behind the examples

The activities use invented outcomes and simplified causal diagrams. These published papers provide the background and examples of how the questions can be tested.

Back to the research Get in touch